Home > News > Content
How to Storage Drill Rod & DTH Hammer?
May 12, 2016

This year the engineering and mining industry is still during the downturn, many drilling equipment underemployment, storage in downtime of drilling rig is easy to overlook the problem of everyone, in fact, storage for crawler drilling equipment and drill tools is very important when you start to use it .

 

How to make the drill rod storage?

Blowing,make sure all the water is dry inside of drill rod,then open the drill shank lubrication part,mainly,it’s the best when you can see the lubricating oil in the bottom of drill pipe.

Drill rod external should be clean,include the main part of drill pipe and screw thread part.Then cover on the connector of male & female,avoiding the dirty is gone inside.

The cover is small and cheap,but it can really helpful for avoiding dirty.

 

Storage and reuse for DTH hammer

Short term storage.Following the below step.

Blowing,make sure DTH hammer inside is dry completely.

Filling one liter of drill shank oil from the top connector

Blowing again,about 10 seconds,it will make all the inner parts of DTH hammer is lubricated.

 

Same way with drill rod, cover on the top & bottom connector.

Lay down the DTH hammer as horizontal position in the dry place.

Long term storage.A little bit different.

Blowing,make sure DTH hammer inside is dry completely.

Unscrewing the top & bottom connector,disassemble the DTH hammer.

Checking,wipe all the inner parts of DTH hammer,it’s better do it inside the workshop.

Use the suitable lubrication oil for all parts.

Assemble the DTH hammer,cover on the top & bottom connector.

Lay down the DTH hammer as horizontal position in the dry place.

 

Fore more knowledge of Drilling rigs&partsplease contact us... 

Website: www.rejeedrilling.com 

Email: manager@rejeegroup.com 

Whatsapp: 0086-13991232350   0086-18629069687






Products List